Stone how seamless splicing? Simple analysis of stone seamless stitching method

In the home decoration, in order to ensure the decoration effect, the splicing of stone will be required to achieve seamless splicing. But many consumers just know the meaning of seamless splicing, but do not know very much about the specific standards. In order to help friends better understand the seamless splicing, the following with everyone to understand a detailed stone seamless splicing standards and methods.

One, stone seamless splicing - what is seamless splicing

Seamless splicing literally means that there is no joint splicing, generally speaking is the naked eye can not see the joint of the two plates there. There is no national standard or other local standards, generally speaking, the industry is about 50 centimeters from the eyes of the board, can not find the seam even if the seamless splicing.

This way of joining together common in post stone, quartz, acrylic and other quality of a material soft artificial stone, they will be used in the splice effection and corresponding color daub glue to achieve seamless effect, such as microcrystalline hard like the artificial Shi Yi that it is difficult to achieve seamless patchwork effect, mainly depends on the state of the art workers and the corresponding processing equipment support.

Two, stone seamless splicing - splicing method

At the time of splicing stone, first of all, according to the requirements of the product assembly plan, arrange the yarn in place in order, and then spray water on each line with a sprayer to show whether the color is one. If there is a difference in color, it should be replaced in time. Color difference is particularly serious to rearrange processing.

The spliced products are kept on the same straight line to show the size error and shape error between the products. Then use the ink box to splice the first and tail of the product to pull a straight line and pop up the need to rest the drawing line, trim into a straight line, and then use 800mm standard straight line ruler to test the straightness of the product.

The front and side of the product are 90 degrees at a right Angle. If the verticality of the splicing lines is different, there will be a mismatch between the product and the product interface piece. In order to solve this problem, it is necessary to measure the perpendicularity of the product in the assembly of the level ruler. If there is any error in the perpendicularity, mark it with a marker pen and then use a hand mill to trim it.

Modeling surface is an important part of the line, the beauty of the line directly on the modeling surface, is based on customers and designers and the development of the product. Therefore, when assembling, we must carefully check the size of the drawing. After the accuracy, the modeling surface of the product is made into a mold according to the drawing, and then the obvious water ripples can be trimmed.

The anastomosis of the joint refers to the continuity and natural transition between the product and the product. After splicing the end of the last piece of product and the first end of the next piece of product, the difference of the height, uneven and modeling surface of the splicing piece should be trimmed in place with a hand mill, and the splicing gap should be as small as possible.